Starting Work on Laying Tiles, Porclavin Tiles, You Shoup Firce Make The Correct Calculation of the Required Number of Tiles. Purchase by ABOUT 10-15% of tiles more. In the Process of Transportation, Laying and Cutting of Tiles, Part of it can be made unusable. Start Laying Tiles from the Lower Corner. An adhesive Solution is applied to the Surface with the Smooth Side of the Trowel, the Same Side Is Evenly Distributed Over the Entire Glueed Surface and the Back of the Wel IS Applied by Grooves. This is Done in Order to Ensure The Better Gluing of Materials. The Tile is Pressed Against the Wall with the Entire Surface and to the Rail Edges. Strongly Shoup Not Be Crushed on the Tile. The Same Is Repeated with Other Tiles. For uniform gluing of tiles, the Masters Adopted the Use of Special Crosses — They Allow You to Maintain A Clear Line of the Picture, Which Greatly Simplifies Yoon Work. The Last Step in Working with Tiles is the Grout of the Seams. IT ShULD ONLY Be Carried out after the Glue Layer Has Finally Dried. All Crosses Are Removed. The Seams are Wiped Diagonally in Relation to the Tile. AFTER The Final Drying of the Grout, The Tile is Wiped with a Dry Rag. Then, if dirt is detected, wipe with a damp (not wet) sponge. And Again Wipes a Dry Rag. That’s Actually the Whole Process.